INTEGRATION INFORMATION FOR THE OEM
It is the responsibility of the OEM / Host product manufacturer to ensure continued compliance to
FCC and ISED Canada certification requirements once the module is integrated in to the Host
product. Please refer to FCC KDB 996369 D04 for additional information.
The module is subject to the following FCC rule parts: 15.207, 15.209, 15.247, 15.403 and 15.407
Host Product User Guide Text
FCC Compliance
This device complies with Part 15 of FCC Rules, Operation is Subject to following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received including interference that cause undesired
operation.
Caution: Any changes or modifications to the equipment not expressly approved by the party
responsible for compliance could void user s authority to operate the equipment.
This equipment has been tested and found to comply within the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures: • Re-orient or relocate the receiving antenna • Increase the separation between the
equipment and receiver
• Connect the equipment into an outlet on a different circuit from that to which the receiver is
connected • Consult the dealer or an experienced radio/TV technician for help.
For products available in the USA/Canada market, only channels 1 to 11 are available for 2.4GHz
WLAN
This device and its antenna(s) must not be co-located or operation in conjunction with any other
antenna or transmitter except in accordance with FCC’s multi-transmitter procedures.
This device operates in the 5.15~5.25GHz frequency range and is restricted to in indoor use only.
IMPORTANT NOTE: FCC Radiation Exposure Statement; Co-location of this module with other
transmitter that operate simultaneously are required to be evaluated using the FCC multi-
transmitter procedures.
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. The device contains an integral antenna hence, the device must be installed to so that
a separation distance of at least 20cm from all persons.
ISED Canada Compliance
To Next Page
Loading...
Need help?
General
