ratiotec rapidcount T 575 User Manual

16
[EN]
Error messages
Error message Solution
Left# counting sensor
Right# counting sensor
Left# counting sensor
Right# counting sensor
. Remove the banknote from the device or clean the
sensors.
. If the error persists, press any key and then perform
a calibration.
CIS fault #(**)!
CIS fault #(**)!
CIS fault #(**)!
. Remove the banknote from the device or clean the
CIS sensor.
. If the error persists, press any key and then perform
a CIS calibration.
Counting sensor dust warning! . Clean the sensors.
. If the error persists, press any key and then perform
a calibration.
Incomplete notes! Remove all banknotes from the feeder and repeat the
counting process.
Width error!
Length error!
Remove the faulty banknote and press the START
button to continue the process.
Cannot Judge Denomination!
Denomination not in circulation!
Denomination dierent!
Remove the faulty banknote and press the START
button to continue the process.
Stacker full! Remove all banknotes from the banknote ejection.
Double notes!
Chained notes!
. Remove all banknotes and repeat the counting
process.
. If the error persists, adjust the feeder by turning the
feed screw anti-clockwise.
Service required! Please contact your ratiotec team.

ratiotec rapidcount T 575 Specifications

General

Brand	ratiotec
Model	rapidcount T 575
Category	Banknote Counter
Language	English