27
© 2003 directed electronics, inc.
When the correct wire has been found, solder the small
GREEN/BLACK wire to the wire which activates in the unlock
position when the key is turned. Connect the GREEN/WHITE
wire to the wire which activates in the lock position when the
key is turned. After these wires have been connected cover the
connection with electrical tape.
step 9
Immobilizer Bypass Modules
Most newer vehicles have a factory engine immobilizer system
designed to prevent any unauthorized use of the vehicle. These
immobilizers will cut off power to the starter and the fuel supply
preventing a thief from starting the vehicle.
There are several types of immobilizers, with the most common
being the resistance based passlock/passlock 2 systems found on
most newer GM vehicles. This system can be bypassed using the
557L immobilizer bypass module available at your local retail
dealer. The majority of transponder-based immobilizer systems
can be bypassed using the 557U immobilizer bypass module
available at your local retail dealer.
warning! Any vehicle equipped with a fac-
tory immobilizer must use an immobilizer
bypass module to remote start. If not used,
the vehicle ignition or fuel supply circuits
could lock up and require a costly trip to
the dealer to reset the computer system.
➜
To Next Page
Loading...