34
© 2003 directed electronics, inc.
go out indicating the change.
4.
RReelleeaassee
. The Program switch can now
be released.
You can advance from feature to feature by pressing and
releasing the Valet/Program switch the number of times neces-
sary to get from the feature you just programmed to the feature
you wish to access. For example, if you just programmed the run
time (Feature 3) and you next want to program parking lights
(Feature 4) to constant, release the Valet/Program switch. Press
and release it once to advance from Feature 3 to Feature 4. Then
press it once more and hold it. The LED will flash in groups of
4 to confirm that you have accessed Feature 4.
The learn routine will be exited if any of the following occurs:
➤ The ignition is turned on.
➤ The Valet/Program switch is pressed too many times.
➤ More than 25 seconds elapses between programming steps.
To Next Page
Loading...