38
© 2003 directed electronics, inc.
88 AACCTTIIVVAATTIIOONN PPUULLSSEE CCOOUUNNTT::
This feature allows the
number of pulses to activate the remote start feature to be
changed from 1, 2, or 3 pulses. The pulse count programmed to
start the vehicle will also be the same required to shut down the
remote start.
99 22nndd IIGGNNIITTIIOONN//AACCCCEESSSSOORRYY OOUUTTPPUUTT::
This will allow
the PINK/WHITE to be used as a 2nd ignition or a
2nd accessory.
1100 AACCCCEESSSSOORRYY SSTTAATTEE DDUURRIINNGG WWAAIITT--TTOO--SSTTAARRTT::
This
will allow the programming of the accessory wire during the
wait-to-start period of a diesel motor. When ON the accessory
comes on when the wait-to-start output is activated and stays
on, dropping out during crank and returning once the car has
started. When OFF the accessory will activate as a normal acces-
sory.
1111 22nndd SSTTAATTUUSS OOUUTTPPUUTT::
If programmed to status mode,
this output will turn on when the remote start is activated. In
defogger mode the output can be programmed to a latched or a
pulsed output. When programmed to the latched output the
status will only stay active for 10 minutes.
1122 UUNNLLOOCCKK OOUUTTPPUUTT::
This will program the unlock output
to one or two pulses.
1133 IIGGNNIITTIIOONN CCOONNTTRROOLLLLEEDD LLOOCCKK::
When programmed
ON the doors will lock when the key is on and all doors are
closed.
To Next Page
Loading...