PRE-PLANNING OPERATION | CR7/CR12 | QUICK START GUIDE
PAGE 25/35 | User manual | 116-8000-017 | Rev. B2
11 PRE-PLANNING OPERATION
You will be automatically redirected to the
next page when the field boundary is created
When a Shapefile is imported, press the
imported field and then “pre-planning”.
If the pre-planning button is blue it has not
yet been done.
When pre-planning is green it has already
been performed.
Pre-planning can be adjusted but it might
cause your “Operation plans” to be deleted.
Optionally, corners can be moved, removed
or added here.
We have already indicated the corners in the
field boundary, so we now don't have to do
anything on this page.
You can press through to the next page.
To Next Page
Loading...
