4
Start a Job
1. To begin a job, touch the icon
on the Home screen. The Start
Job - Verify Settings screen will
display.
By default, the field computer
creates a new job when the Start
Job - Verify Settings screen will
display. Touch the at any time
to cancel the job setup process.
2. The icon displays the current
direction of travel detected by the
field computer. If this indicator
displays the direction of travel incorrectly, touch the icon to manually toggle the
course direction for the current or last direction of travel.
3. Touch the Job button and select the Create New icon along the top of the
screen to rename the new job file or select a previous job file from the list.
4. When finished, touch the icon to return to the Start Job - Verify Settings
screen.
5. If an optional section control feature will be used, touch the AccuControl button
to enable the feature. To create or load a zone map, select Enable Zone Map.
6. Touch the Product buttons to select the control mode and set the target
application rate for the job.
Note: If the CAN Switch Box is installed, the product control mode must be set
using the Product Control switches on the switch box. The field computer
will display the current selection for each product.
If an optional variable rate key has been activated, a prescription map may be
selected by touching the symbol on the Product button.
7. When finished setting up features and options for the job, touch the icon
on the Start Job - Verify Settings screen to accept the displayed settings.
8. If the optional AutoBoom system is detected on the CANbus, the AutoBoom
Setup screen will be displayed. See the AutoBoom section in this guide or the
AutoBoom Calibration and Operation manual for more information.
9. Touch the icon to display the Guidance screen.
To Next Page
Loading...
Need help?
General
