CHAPTER 3
10 RCM Dry Manure/Litter Setup Guide
FIGURE 2. Setup System
8. Set the number of spinner or fan RPM sensors installed on the implement to 1 if one is installed.
IMPORTANT: Do not check the box to enable Fan/Spinner RPM Control for Pull-Behind applications.
NOTE: Enable Fan/Spinner Control may be used on pull-type or truck mounted boxes which are configured
with hydraulically driven spreaders or beaters.
9. Select the Next button in the lower, right corner of the page to proceed.
FIGURE 3. Setup Fan/Spinner RPM
10. Use the drop down list to select the Granular Fertilizer option.
11. Select the Next button in the lower, right corner of the page to proceed.
To Next Page
Loading...
