Manual # 016-0130-030 Rev B
15
3. Press Function Key 4 to toggle the adjustment mode between the
lightest and heaviest setpoints. Once the correct setpoint is selected,
adjust the setpoint using Function Keys 2 (-) or 3(+).
4. After making adjustments, the boom down speed can be tested by
pressing the Function Key 1 to enable the left boom. The left boom
down speed dial will now adjust the system pressure between the
lightest setpoint (0 on the dial) and the heaviest setpoint (10 on the
dial).
Helpful Hint: By increasing the lightest value, the “zero”
setting becomes lighter and by decreasing the heaviest value,
the “ten” setting becomes heavier. .
or
Hvst
To Next Page
Loading...
Need help?
General
