Raychem QuickStat-TC - Vacation Mode; Error Messages

Vacation Mode
Inthismode,theQuickStat-TCissettotheVacationsetpoint
temperatureandwilloverrideallprogramminguntilVacationmodeis
disabled. To place the QuickStat-TC in this mode:
1. Press the
button, and the icon appears on the display.
2. TodisableVacationmode,pressthe Mode/Ret button to change the
modetoAutomatic
orManual .
To reset the QuickStat-TC to factory default settings:
3. Turn the thermostat to Off.
4. Press the up button
and switch the thermostat On.
5. Afterthethermostatsetupiscompleted,releasetheupbutton
.
Error Messages
The measured temperature is below the thermostat’s display
range. Heating is activated.
The measured temperature is above the thermostat’s display
range. Heating is deactivated.
Verifythefloorsensorconnectiontothethermostat.
QuickStat-TC Installation & Operation Manual
5
400-115-052