Raymarine AIS4000 - Turning the AIS Transceiver on; Passwords and Security

Installation and configuration
Page 35
If the USB connection is removed from the PC or Mac during use
you must reset the connection before further use. To reset the
connection, disconnect then reapply power to the AIS before
closing and relaunching any PC or Mac applications using the
USB connection. Finally, reconnect the USB cable between the
PC or Mac and the AIS transceiver
3.8 Turning the AIS transceiver on
The AIS transceiver does not have an On / Off switch and will operate
immediately that power is applied to the unit.
3.9 Passwords and security
Certain important information stored within the AIS transceiver cannot be
changed without knowledge of the password. When trying to edit any of this
protected information you will be prompted to enter the password.
The password entry screen is shown in Figure 17. Highlight the required
character, then press ‘Select’ to enter that character. When all characters of
the password have been entered, select ‘OK’.
!
16:58:29
SOG 21.1kt
UTC + 1h
COG 88.0°
50° 32.0286’ N
0° 55.2715’ W
PASSWORD SETTINGS
Enter the current password:
1234567890 .
QWE R T Y U I O
A
ZXCVBNM
!? OK
P
SDFGHJ KL