Raymarine axiom pro 9 RVX

Questions and Answers

D
danielgutierrezAug 5, 2025
How to fix Wi-Fi issues on Raymarine Marine GPS System?
- A
  April IngramAug 5, 2025
  Having trouble with Wi-Fi on your Raymarine Marine GPS System? Here's what to check: * **Wi-Fi not enabled:** Make sure Wi-Fi is enabled on both devices and rescan for available networks. * **Wi-Fi automatically turning off:** Power cycle/reboot devices and rescan for available networks, as some devices may turn off Wi-Fi to save power. * **Device not broadcasting:** Try enabling broadcasting of the device’s network in the Wi-Fi settings. If that doesn't work, manually enter the device’s Wi-Fi Name/SSID and passphrase in the connection settings. * **Devices out of range/signal blocked:** Move devices closer together or remove obstructions and rescan for available networks.
P
Penny TuckerAug 9, 2025
What to do if Raymarine axiom pro 9 RVX display is behaving erratically?
- A
  Alexis RoseAug 9, 2025
  If your Raymarine Marine GPS System display is behaving erratically, try the following: * **Check fuses and breakers:** Inspect the relevant fuses and breakers. * **Inspect power supply cable:** Check the power supply cable for any damage and ensure all connections are tight and free from corrosion. * **Verify power source:** Ensure the power source provides the correct voltage and sufficient current. * **Software update:** Check for software updates on the Raymarine website. * **Factory reset:** As a last resort, perform a factory reset. Note: This will erase all settings and data stored on the product, so save any important data beforehand.
L
Lisa AlvaradoAug 13, 2025
Why is my Raymarine axiom pro 9 RVX Marine GPS System connection so slow?
- S
  Spencer BonillaAug 13, 2025
  If your Raymarine Marine GPS System connection is slow or keeps dropping, consider the following: * **Distance:** Move devices closer together, as Wi-Fi performance degrades over distance. For fixed installations like a Quantum Radar, enable the Wi-Fi connection on an MFD closer to the device. * **Interference:** Change the Wi-Fi Channel of the device you are trying to connect to and retry the connection. Temporarily switch off each device in turn until you have identified the device causing the interference.
M
Michael GriffithAug 22, 2025
What causes no depth reading on my Raymarine axiom pro 9 RVX?
- W
  Willie MayAug 22, 2025
  If your Raymarine Marine GPS System shows no depth reading or has lost bottom lock, check these potential issues: * **Transducer location:** Ensure the transducer is installed according to its instructions. * **Transducer angle:** Adjust the transducer angle if it's too great, as the beam might be missing the bottom. * **Transducer kicked-up:** If the transducer has a kick-up mechanism, ensure it hasn't kicked up due to hitting an object. * **Insufficient power source:** Check the power supply voltage as close to the unit as possible under load. * **Damaged or fouled transducer:** Check the transducer for damage and ensure it's free from debris/fouling.
F
farmeralanAug 26, 2025
What to do if Raymarine Marine GPS System displays 'No Fix' GNSS status?
- C
  Craig WebbAug 26, 2025
  If the “No Fix” GNSS status icon is displayed on your Raymarine Marine GPS System, consider the following: * **Geographic location or conditions:** Check periodically to see if a fix is obtained in better conditions or another geographic location. * **GNSS connection fault:** Ensure that external GNSS connections and cabling are correct and fault free. * **External GNSS receiver location:** Ensure the GNSS receiver has a clear view of the sky. * **GNSS installation problem:** Refer to the installation instructions.
C
collinsclaudiaOct 30, 2025
How to troubleshoot a Raymarine axiom pro 9 RVX Marine GPS System that won't turn on?
- V
  Victoria StantonOct 31, 2025
  If your Raymarine Marine GPS System isn't turning on or keeps turning off, there are several potential causes: * **Blown fuse/tripped breaker:** Check the condition of the fuses and breakers, replacing them if necessary. If the fuse keeps blowing, inspect for cable damage, broken connector pins, or incorrect wiring. * **Poor power supply cable/connections:** Ensure the power cable connector is fully inserted and locked. Look for damage or corrosion on the cable and connectors, replacing if needed. Flex the power cable near the display connector to see if it causes the unit to restart or lose power. Also, check the vessel's battery voltage and the condition of the battery terminals and power supply cables, ensuring they are secure, clean, and free from corrosion. * **Incorrect power ...
L
lhowardNov 16, 2025
Why is scrolling image not being displayed on Raymarine Marine GPS System?
- U
  uconradNov 16, 2025
  If the scrolling image isn't being displayed on your Raymarine Marine GPS System, here's what you can check: * **Sonar disabled:** Ensure 'Ping Enable' is selected in the Sonar app's Sounder menu. * **Incorrect transducer selected:** Verify the correct transducer is selected in the Sonar app's Transducer menu. * **Damaged cables:** Check the transducer cable connector is fully inserted and locked. Inspect the power supply cable and connectors for damage or corrosion. Flex the cable near the display connector to check for loose connections. Also, check the vessel's battery voltage, the condition of the battery terminals, and power supply cables. * **Damaged or fouled transducer:** Check the transducer's condition, ensuring it's not damaged and free from debris/fouling. * **Wrong ...

Summary

Chapter 1: Important Information

Product Installation and Operation Warnings

Critical warnings for safe installation and operation of the product, emphasizing adherence to instructions.

High Voltage Safety Warning

Warning regarding high voltage within the product and restrictions on user-serviceable parts.

RF Exposure and Compliance Guidelines

Information on RF exposure limits and compliance statements for general population exposure.

Regulatory Compliance Statements

FCC and Industry Canada compliance statements, including interference notices.

Chapter 2: Document and Product Information

Product Documentation Availability

Lists applicable documentation, including manuals and templates, available for download from Raymarine.

Applicable Axiom Pro Products

Details the specific Axiom Pro Multifunction Displays to which this document applies.

Compatible Transducer Types

Lists compatible transducer types for Axiom Pro MFDs, including RealVision and DownVision.

Included Parts for Axiom Pro 9 and 12

Details the components included in the package for Axiom Pro 9 and 12 models.

Chapter 3: Installation

Selecting an Installation Location

Guidance on choosing an optimal and safe location for installing the MFD, considering ventilation and interference.

Mounting Options Overview

Describes the available mounting methods for the Axiom Pro MFD, including surface and bracket mounting.

Surface Mounting Procedure

Step-by-step instructions for performing a surface mount installation of the MFD.

Bracket (Trunnion) Mounting Method

Instructions for mounting the Axiom Pro 9 and 12 MFDs using the supplied trunnion bracket.

Chapter 4: Connections

Connection Interface Overview

Visual guide to the various connectors and their purposes on Axiom Pro MFDs.

Power Supply Connection

Detailed instructions and considerations for connecting the MFD to the vessel's power supply.

NMEA 2000 (SeaTalkng) Network Setup

Information on connecting the MFD to a SeaTalkng or NMEA 2000 backbone network.

NMEA 0183 Data Connection

Guidance on connecting NMEA 0183 devices to the MFD using the provided cable.

Transducer Connectivity Options

Details on connecting various sonar transducers to the Axiom Pro MFD variants.

Network Cabling and Setup

How to connect the MFD to a network using RayNet cables or adapters.

GA150 External Antenna Connection

Information on connecting the GA150 accessory to improve GNSS receiver reception.

Accessory Device Connectivity

Instructions for connecting accessories like the RCR-SDUSB or RCR-2 to the MFD.

Analog Video Input Setup

How to connect analog video sources, such as cameras, to the MFD.

Chapter 5: Maintaining Your Display

Service and Maintenance Procedures

Information on routine checks and recommendations for product service and maintenance.

Product Cleaning Guidelines

Best practices for cleaning the display case, screen, and sun cover.

Chapter 6: Troubleshooting

Troubleshooting Introduction

Introduction to troubleshooting common problems associated with installation and operation.

Power-Up and Startup Issues

Solutions for issues related to the MFD not turning on or entering a restart loop.

GNSS Performance Problems

Diagnosing and resolving problems with GNSS fix and satellite reception.

Sonar System Malfunctions

Solutions for issues with sonar scrolling, depth readings, and image quality.

Wi-Fi Connectivity Issues

Steps to resolve problems finding networks, connecting, or maintaining Wi-Fi stability.

Touchscreen Operational Issues

Solutions for issues where the touchscreen is not operating as expected.

General System Behavior Troubleshooting

Addresses general erratic behavior, frequent resets, or software mismatches.

Chapter 7: Technical Support

Product Support and Servicing Information

Information on how to access Raymarine's support services, including web, telephone, and email.

Learning Resources and Tutorials

Details on video tutorials, training courses, FAQs, and technical support forums.

Chapter 8: Technical Specification

Axiom Pro Model Specifications

Detailed technical specifications for Axiom Pro models, covering power, environmental, LCD, and data connections.

Internal Sonar System Specifications

Technical details for RealVision 3D and 1kW sonar capabilities.

Internal GNSS Receiver Specifications

Technical details regarding the internal GNSS receiver's compatibility and accuracy.

Chapter 9: Spares and Accessories

Axiom Pro Model Accessories

Lists various accessories available for Axiom Pro MFDs, including adaptor cables and legacy MFD adaptor plates.

Axiom Pro Replacement Parts

Details part numbers for common spare items such as cables and keypad assemblies.

RayNet Cable and Connector Guide

Information on RayNet cables, pullers, and couplers for network connectivity.

SeaTalk ng Cable and Accessory Guide

Lists SeaTalk ng cables and accessories for NMEA 2000 network integration.

Chapter 10: Radar Application

Radar App Overview

Introduction to the Radar app, its purpose, and display capabilities.

Radar Feature Comparison

Comparison of features and settings available across different Radar scanner types.

Opening the Radar Application

Steps to launch the Radar app and troubleshoot connection or power issues.

Radar Setup Procedures

Guidance on selecting a Radar scanner, configuring dual range, and setting up transmission.

Radar Modes Explained

Description of different Radar modes (Harbor, Buoy, Coastal, etc.) and their optimal use.

Range and Bearing Indicators

Understanding how to use range rings, VRM, and EBL for target measurement.

Target Tracking Functionality

How to acquire, track, and manage targets displayed on the Radar.

Radar Sensitivity Controls

Adjusting Gain, Rain, Sea, and Color Gain settings for optimal image clarity.

Radar Settings Menu Options

Overview of settings for transmission, motion, orientation, and presentation.

Chapter 11: Dashboard App

Dashboard App Overview

Introduction to the Dashboard app for viewing system data and controlling digital switching.

Dashboard Settings Menu

Customizing pages, importing custom pages, and managing circuit settings.

Chapter 12: Camera App

Camera App Overview

Viewing IP and analog video feeds, recording, and playback using the Camera app.

Opening the Camera Application

Launching the Camera app and troubleshooting display or connection issues.

Camera Settings Configuration

Adjusting image settings, scene modes, and camera motion for optimal performance.

Chapter 13: Audio Application

Audio App Overview

Controlling compatible NMEA 2000 entertainment systems connected via SeaTalkng network.

Opening the Audio App

Launching the Audio app and troubleshooting 'No audio device found' messages.

Getting Started with Audio Features

Selecting audio sources, muting, browsing tracks, and managing radio stations.

Audio App Menu Options

Accessing tracks, channels, audio sources, power settings, and audio app settings.

Chapter 14: Mobile App Support

Raymarine Mobile Applications

Information on available Raymarine mobile apps for controlling MFD functions.

Connecting a Mobile Device to MFD

Steps to connect a mobile device to the MFD via Wi-Fi for app control.

Controlling MFD with RayControl App

Using the RayControl app to remotely view and control the MFD's touchscreen interface.

Controlling MFD with RayRemote App

Using the RayRemote app to control the MFD via on-screen equivalents of physical buttons.

Viewing MFD Screen with RayView App

Using the RayView app to mirror the MFD's screen onto a mobile device.

Chapter 15: Troubleshooting

General Troubleshooting Guidance

Introduction to troubleshooting common problems associated with installation and operation.

Power-Up and Startup Issues

Solutions for issues related to the MFD not turning on or entering a restart loop.

Radar Connectivity and Performance Problems

Troubleshooting problems with Radar connection, image quality, and display issues.

GNSS;GPS Signal Problems

Diagnosing and resolving issues with GNSS fix and satellite reception.

Sonar System Malfunctions

Solutions for issues with sonar scrolling, depth readings, and image quality.

Camera Feed and Control Issues

Troubleshooting problems with video display, PTZ controls, and camera connections.

Wi-Fi Connectivity Troubleshooting

Steps to resolve problems finding networks, connecting, or maintaining Wi-Fi stability.

Wireless Display Connectivity Issues

Troubleshooting problems with connecting or maintaining a wireless display connection.

Data Communication Errors

Resolving issues where instrument, engine, or system data is unavailable or missing.

Touchscreen Responsiveness Issues

Solutions for issues where the touchscreen is not operating as expected.

Chapter 16: Technical Support

Product Support and Servicing Information

Information on how to access Raymarine's support services, including web, telephone, and email.

Learning Resources and Tutorials

Details on video tutorials, training courses, FAQs, and technical support forums.

Raymarine axiom pro 9 RVX Specifications

General

Display Size	9 inches
Waterproof Rating	IPX6 and IPX7
Sonar Support	Yes
Display Type	IPS LCD
Transducer Compatibility	CHIRP DownVision, CHIRP SideVision
Networking	Ethernet, NMEA 2000, Wi-Fi
GPS Receiver	10 Hz
Sonar	RealVision 3D, CHIRP Sonar, DownVision
Video Input	1x CVBS video input
Card Slots	2x microSD card slots
Operating Temperature	-25°C to +55°C
Nominal Supply Voltage	12 V DC / 24 V DC
Radar Support	Yes
Power Supply	12 V DC / 24 V DC
Display Resolution	1280 x 720 pixels