Why is the Wi-Fi signal weak on my Raymarine Marine GPS System?
If you are experiencing a weak or intermittent Wi-Fi signal on your Raymarine Marine GPS System, temporarily disable each wireless device in turn until you have identified the device causing the interference.
Why is my Raymarine Marine GPS System showing an incorrect speed reading?
If you're getting an incorrect speed reading on your Raymarine Marine GPS System, check that the paddle wheel is clean. Add a speed offset if none is set. Re-calibrate the equipment if necessary.
Why can't I control the thermal camera from my Raymarine Marine GPS System display?
If you cannot control the thermal camera from the Raymarine display or keyboard, ensure the thermal camera application is running on the multifunction display, not the video application.
How to fix incorrect radar bearing on Raymarine Marine Equipment?
If the radar bearing of a target on the Raymarine Marine Equipment screen is incorrect, check and adjust the radar bearing alignment.
Why does my Raymarine Marine Equipment display behave erratically?
If your Raymarine Marine Equipment display behaves erratically with frequent unexpected resets, system crashes, or other erratic behavior, check the relevant fuses and breakers. Ensure that the power supply cable is sound and that all connections are tight and free from corrosion. Also, verify that the power source provides the correct voltage and sufficient current. You may need to perform a factory reset. For software issues, go to www.raymarine.com and click on support for the latest software downloads.
Why is instrument data missing from some Raymarine Marine Equipment displays?
If instrument or other system data is missing from some but not all displays on your Raymarine Marine Equipment, check that all required equipment is connected to the network. Verify the status of the Raymarine network switch and ensure that SeaTalkhs/RayNet cables are free from damage. If a software mismatch between equipment is suspected, contact Raymarine technical support.
Why can't I control the thermal camera from my Raymarine Marine Equipment?
If you cannot control the thermal camera from the Raymarine display or keyboard, ensure the thermal camera application is running on the multifunction display, as opposed to the video application which does not have camera controls.
How to fix weak Wi-Fi signal on Raymarine Marine Equipment?
If you are experiencing a weak or intermittent Wi-Fi signal with your Raymarine Marine Equipment, temporarily disable each wireless device in turn until you have identified the device causing the interference.
Why won't my Raymarine Marine GPS System radar initialize?
If your Raymarine Marine GPS System radar will not initialize and the Voltage control module (VCM) is stuck in “sleep mode”, check the power connection at the VCM. Verify the voltage at the input is 12 / 24 V and the voltage at the output is 40 V.
Why is the image on my Raymarine Marine GPS System noisy?
If the image on your Raymarine Marine GPS System is noisy, ensure that the video cable is no longer than necessary. Also, ensure proper cable separation, and do not run data and power cables in close proximity with each other.
General| Brand | Raymarine |
|---|---|
| Model | c95 |
| Category | Marine GPS System |
| Language | English |
To Next Page
