S1000 Autopilot Installation Guide 25
Yellow: SeaTalk Data
Red: SeaTalk +12 V
Black: SeaTalk 0 V
SeaTalk
Each time power is applied to an S1000 Autopilot connected to a
Raymarine GPS (via NMEA or SeaTalk), the S1000 will set the GPS
filtering to WEAK.
D7549-1
Purple
Red
Black
Scotchlock connector
White
Scotchlock connector
NMEA connector (not
supplied), from GPS
GPS requirement
The S1000 must receive GPS information, to function
correctly. Use the Data Cable supplied, to connect the
Course Computer to a GPS, using either of the
following methods:
1. To a Raymarine GPS via SeaTalk connections.
2. To a Raymarine GPS via NMEA spur.
3. To a non-Raymarine GPS via NMEA spur.
External
buzzer
NMEA Spur
Course Computer
Data
cable
For details of the NMEA Spur
connections, refer to Diagram D
Diagram C: Connecting the Data Cable
When connecting NMEA data from an external source, always
connect via the NMEA spur on the Data Cable. Do NOT connect
NMEA data from an external source directly to the connector on the
Course Computer.
When you have completed the electrical
connections, secure the wires at the
Course Computer
87040_1.book Page 25 Wednesday, December 22, 2004 12:32 PM
To Next Page
Loading...
