What to do if my Raymarine S1000 Autopilot System displays 'CURRENT LIMIT'?
If your Raymarine Autopilot System displays 'CURRENT LIMIT', it indicates a serious drive failure. The drive is drawing excessive current due to a short-circuit or jamming. You should check the drive unit.
What does 'DRIVE STOPPED' mean on my Raymarine S1000 Autopilot System and how to fix it?
The 'DRIVE STOPPED' message on your Raymarine Autopilot System means the autopilot cannot turn the rudder. Check the drive unit to resolve this issue.
What does 'OFFCOURSE' mean on my Raymarine S1000?
The 'OFFCOURSE' message on your Raymarine Autopilot System indicates that you have been off course from the locked heading for more than 20 seconds. Press PILOT to continue on the same heading or STANDBY for manual control.
Why is my Raymarine S1000 displaying 'NO DATA'?
The 'NO DATA' message on your Raymarine Autopilot System indicates that the autopilot is in Track mode but not receiving SeaTalk navigation data, or the GPS signal strength is low. This message will clear when the signal improves.
What does 'NO GPS FIX' mean on my Raymarine Autopilot System?
The 'NO GPS FIX' message on your Raymarine Autopilot System means that your GPS is receiving a low strength signal. This will clear when the signal improves.
How to fix 'LRN FAIL 1, 2 or 4' error on Raymarine Autopilot System?
The 'LRN FAIL 1, 2 or 4' error on your Raymarine Autopilot System indicates that AutoLearn was not completed successfully. Repeat the AutoLearn procedure to resolve this issue.
How to fix Raymarine S1000 Autopilot System when boat overshoots when turning onto a new course?
If your boat overshoots when turning onto a new course with the Raymarine Autopilot System, it indicates that the rudder gain is too high. Complete AutoLearn or decrease the gain setting.
How to fix Raymarine Autopilot System when boat turns slowly?
If your boat turns slowly and takes a long time to come onto course using the Raymarine Autopilot System, it suggests that the rudder gain is too low. Complete AutoLearn or increase the gain setting.
Why is my Raymarine S1000 displaying 'NO GPS COG'?
The 'NO GPS COG' message on your Raymarine Autopilot System means that the autopilot is not receiving valid COG data from your GPS system. Check the connections and ensure that your GPS unit is set up to send out COG data.
Why is my Raymarine S1000 Autopilot System not responding?
Drive the boat for 30 seconds at above 2.5kts and retry. Check autopilot connections.
General| Brand | Raymarine |
|---|---|
| Model | S1000 |
| Category | Autopilot System |
| Language | English |
To Next Page
