S1000 Autopilot Installation Guide 31
Commissioning using Autolearn - sheet 2
D7557-1
5.
Press PILOT to begin. Your boat will then make a series of
zig-zag turns and the S100 display will show the Autolearn
step numbers (counting up). A typical Autolearn process
takes from 7 to 27 steps.
6.
At the end of a successful Autolearn process, the display
shows LRN PASS. When this occurs, hold down
STANDBY for 2 seconds, to save the Autolearn values and
enter autopilot Standby Mode.
If an Autolearn process fails, the display shows LRN FAIL.
Press and release STANDBY to return to Autolearn and
repeat the process.
LEARNING...
STEP 1
LRN PASS
LRN FAIL
87040_1.book Page 31 Wednesday, December 22, 2004 12:32 PM
To Next Page
Loading...
