30 S1000 Autopilot Installation Guide
3.
If the outboard motor(s) turn(s) to give the correct direction of steer, proceed with the
Autolearn procedure.
If the outboard motor(s) does/do not move correctly, DO NOT USE THE BOAT. At the
S100 Remote, hold down STANDBY for 2 seconds to leave Setup mode and return to
Standby mode, then check that the S1000 components have been installed correctly. In
particular, check that the autopilot pump wiring and hydraulics are connected
correctly.
D7705-1
Hold down < and > in turn, and as each of these is pressed, ensure that the outboard
motor(s) turn(s) to give the correct direction of steer.
2.
Checking direction of turn - sheet 2
WARNING:
At least 0.25 nm (500 m) of clear sea space
At least 0.04 nm (100 m)
of clear sea space
1 minute
(approximately)
Wind
Continue on sheet 2
The Autolearn process takes your boat through a series of zig-zag
maneuvers, so a significant amount of CLEAR SPACE is required in
front of your boat. Do NOT start Autolearn unless this space is
available.
D7508-1
Autolearn procedure - sheet 1
87040_3.book Page 30 Thursday, February 17, 2005 2:01 PM
To Next Page
Loading...
