Chapter 3: Installation 17
3. Referring to the
Fitting the flush mount bezel
illustration, insert the panel
seal (8) in the corresponding recess on the back of the flush mount bezel (7).
4. Place the instrument (11) face upwards on a flat surface, then place the rub-
ber keypad (10) in position around the display window (i.e. so that each but-
ton outline is located over its associated button on the instrument).
D8148-1
Fitting the flush mount bezel
87 9 10 11 12
D8149-1
81265_1.book Page 17 Monday, December 5, 2005 9:23 AM
To Next Page
Loading...
