10
SeaTalk systems:
• Label both ends of the SeaTalk
ng
-to-SeaTalk adaptor cable, and attach it to an
existing instrument or connect it to a connector block on the system.
• Route the cable to the location in which you plan to mount the ST70 controller.
Note: Check that the cable reaches the required location. If you wish to place the ST70 control-
ler further than 400mm from the connection point you will need to purchase an appropriate
SeaTalk
ng
or SeaTalk
ng
-to-SeaTalk cable.
2. Cut mounting holes
• Use the appropriate flush- or surface-mount template to cut the mounting slot for
the autopilot controller and to drill holes for the fixing screws. See the back of this
book for templates.
• Clean and de-burr the mounting surface
ST70 controller
ST60+ instrument
D10421-1
SeaTalk cable
SeaTalk cable
SeaTalk 3 way block
SeaTalk cable
ST70 controller
ST60+ instrument
SeaTalk
ng
to SeaTalk cable
SeaTalk
ng
to
SeaTalk cable
87071-1.book Page 10 Monday, April 21, 2008 3:34 PM
To Next Page
Loading...
