Raymarine ST70 - Page 16

8 ST70 Pilot Controller Reference Guide
Units
1. Use < and > to scroll to the Units box and press
ENTER .
2. The summary box shows the current settings.
Press
ENTER to display the second page of
settings.
3. Press
ENTER to display the Units menu.
4. Use < and > and press
ENTER to select a unit to
change. These are:
• Speed (knots, mph, km/h)
• Distance (nm, statute miles, km)
• Depth (metres, feet, fathoms)
• Wind speed (knots, metres/sec)
• Heading (true, magnetic)
• Flow rate (galls/hr, liters/hr)
• Temperature (°C, °F)
5. Use < and > to scroll to the required setting.
6. Press
ENTER to accept the new value and exit,
or
CANCEL to exit without making any change.
7. When you have finished setting the units, use <
and > to scroll to the Continue box, then press
ENTER to return to the pilot screen.
Press ENTER to select.
Display Settings
Units
i
D10839-1
Change the default unit settings.
D9439-1
i
Speed KTS
Distance NM
Depth FT
Wind Speed
KTS
Heading M
These are your current settings.
Units
Press ENTER to continue
Flow Rate
G/H
Temperature
C
o
Press ENTER to select.
Units
Wind Speed Units
D10918-1
D9442-1
i
i
Press ENTER to accept
Wind Speed Units
KTS
Use < & > to adjust.
CANCEL exits without saving.