Raymarine ST70 - Wind Trim; Wind Selection

16 ST70 Pilot Controller Reference Guide
Wind Trim
Wind Trim controls the sensitivity of the pilot when
steering in wind vane mode.
1. Press
MENU , then use < and > to scroll to
Autopilot Calibration and press ENTER .
2. Use < and > to scroll to
Vessel Settings and
press ENTER .
3. Use < and > to scroll to
Sailboat Settings and
press
ENTER .
4. Use < and > to scroll to
Wind Trim and press
ENTER .
5. Use < and > to increase or decrease the auto
tack delay.
6. Press
ENTER to accept the change or CANCEL
to exit without making any changes.
Wind Selection
You can specify whether the wind source is to be
true or apparent when steering in wind vane mode.
1. Press
MENU , then use < and > to scroll to
Autopilot Calibration and press
ENTER .
2. Use < and > to scroll to
Vessel Settings and
press
ENTER .
3. Use < and > to scroll to
Sailboat Settings and
press ENTER .
4. Use < and > to scroll to
Wind Selection and
press
ENTER .
5. Use < and > to switch between True and Appar-
ent.
6. Press
ENTER to accept the change or CANCEL
to exit without making any changes.
Press ENTER to select.
Sailboat Settings
Wind Trim
D
10853-1
Press ENTER to select.
Wind Trim
i
D10852-1
Set the response to wind
direction changes
5
Press ENTER to select.
Sailboat Settings
Wind Selection
D10855-1
Press ENTER to select.
Wind Selection
i
D10854-1
Select wind source.
True