Raynor Navigator 1245RGD User Manual

Raynor Garage Doors
1101 E. River Road
Dixon, Illinois 61021
GARAGE DOOR OPENER
Model 1245RGD
1/3 HP
For Residential Use Only
Complies with UL 325
regulations effective
January 1, 1993
®
Owner’s Manual
■ Please read this manual and the enclosed safety materials carefully!
■ Fasten the manual near the garage door after installation.
■ The door WILL NOT CLOSE unless the Protector System
®
is connected and
properly aligned.
■ Periodic checks of the opener are required to ensure safe operation.
■ The model number label is located on the front panel of your opener.

Raynor Navigator 1245RGD Specifications

General

Brand	Raynor
Model	Navigator 1245RGD
Category	Garage Door Opener
Language	English

Summary

Garage Door Opener Assembly Steps

Attach T-Rail to Motor Unit

Connects the T-rail to the motor unit for the opener system.

Attach Chain and Install Sprocket Cover

Secures the chain to the sprocket and installs the protective cover.

Tighten Garage Door Opener Chain

Important Installation Safety Warnings

Determine Header Bracket Location

Install Header Bracket

Attach T-Rail to Header Bracket

Position Garage Door Opener

Hang Garage Door Opener

Install Door Control

Install Light and Lens

Attach Emergency Release Rope and Handle

Electrical Requirements for Opener

Install Safety Reversing Sensor System

Installing the Sensor Brackets

Mounting brackets for safety sensors on door tracks, walls, or floor.

Mounting and Wiring Safety Sensors

Connects the safety sensors to the opener unit.

Aligning the Safety Sensors

Ensures proper alignment of the safety sensor beam for reliable operation.

Fasten Door Bracket

Connect Door Arm to Trolley

Adjust Travel Limits for One-Piece Doors

Adjust UP and DOWN Travel Limits

Adjust Opener Force Settings

Test Safety Reversal System

Test Protector System®

Operation and Safety Instructions

Using Your Garage Door Opener

Explains how to activate and use the garage door opener.

Using Wall-Mounted Door Control

Open Door Manually

Troubleshooting Common Opener Issues (Part 1)

Opener Not Responding to Controls

Diagnosing why the opener fails to respond to any control input.

Opener Fails to Respond to Door Control

Opener Fails to Respond to Remote Control

Troubleshooting Common Opener Issues (Part 2)

Door Opens and Closes Unintentionally

Door Fails to Open Completely

Door Fails to Close Completely

Door Opens But Will Not Close

Door Reverses Without Apparent Cause (No Light Blink)

Door Reverses With Blinking Lights

Opener Strains or Requires Maximum Force

Opener Motor Hums Then Stops

Programming Remote Controls and Keyless Entry

Add Additional Hand-held Remote Control

Instructions for pairing new remote controls with the opener.

Erase All Codes From Motor Unit Memory

Add or Change Keyless Entry PIN

Steps to program or modify the keyless entry system PIN.