4
Safety Guidelines
Risk of mechanical extrusion
The printing platform will move up and down while the printer is working, there is a risk of
mechanical extrusion which was generated by the improper operation.
Wear protective gloves
Good ventilation
Risk of sharp edge cutting
After printing, a shovel blade is used to separate printed models from the printing platform.
There is a risk of getting injured by the sharp edge cutting of the shovel blade.
Risk of flammability of cleaning solvent
The printed parts should be cleaned with cleaning solvent, such as IPA or 95% alcohol.
Wear goggles
Please keep the protective cover/door closed normally when the printer is in service.
It is strictly forbidden to put hands or other parts of the body into the printing area during
the printing.
Cut-resistant gloves should be worn during the operation of separating printed
parts from the platform.
The blade of the shovel should not be orientated to your body during the usage.
Please keep good ventilation and keep away from heat and fire sources when storing or
using cleaning solvent.
Please wear disposable medical gloves when operating the devices to avoid direct
contact with the resin material.
Please wear cut-resistant gloves when separating the printed models from printing
platform with a shovel.
Areas for printer installation and post-processing should be well ventilated.
If any operation or maintenance work is needed to proceed while the printer is working,
anti-UV goggles should be worn accordingly.
Goggles should be worn to avoid the injury caused by the splashing fragment which
was generated by the operation of separating printed parts from the printing platform.
Risk of scalding
The printer was equipped with heater, then be wared to avoid scalding if the heater is turned on.
To Next Page
Loading...