Installation
MP150 Rev. E3 07/2013 23
3. Under <This connection uses the following items> select <Internet Protocol (TCP/IP)> and click
on <Properties>:
4. Activate the radio button <Use the following IP address> and make the following settings:
IP address: 192.168.42.x
where x is an address between 0 and 255 except 30 which is already
used by the linescanner by factory default
Subnet mask: 255.255.255.0
Default gateway: {empty}
5. Close all dialog boxes by pressing on <OK>.
To Next Page
Loading...