RayTek MX6 User Manual

37
Appendix A - Unit functions
36
Appendix A - Unit functions
The Data button
Press Data once to activate the log
mode of the thermometer and the
camera. With the right logger file
configuration, you can store
temperature values and photos.
The configuration of the logger file
is performed by the companion
software.
By pressing the Data button twice, one of the
following four displays appears.
“RCL” is displayed for the recall mode.
A photo and
a tempera-
ture value
have been
stored at this
Logger posi-
tion.
Only a
temperature
value has
been stored
at this logger
position.
Camera is
active at this
logger posi-
tion. Nothing
has been
stored.
Camera is
inactive at
this logger
position.
Nothing has
been stored.
The Display button
The last ten measurements are
shown in the bar graph on the
unit’s display. Auto Range of the
bar graph is automatically defined
by the measured maximum and
minimum value. Manual Range
(Man Range) is user defined.
CYCLE allows the adjustment of
the display interval of the bar
graph.
Press Display once to see how
many photos are already taken.
This sets up the BEGIN value for
the graphic display of the bar
graph. The graphic display shows
the temperature as a picture.
This sets up the END value for the
graphic display of the bar graph.

RayTek MX6 Specifications

General

Brand	RayTek
Model	MX6
Category	Thermometer
Language	English