16
17
Basic Mode
Basic Mode
Once you have downloaded all data from the
unit to the PC, save the data as library.lgg file.
To edit a picture, click on it once with the left
mouse button. It will be enlarged.
Now you are able to add discriptions to the
photo or to insert a drawing of the laser circle.
This may be necessary, if the ambient light was
too bright while taking the photo and the laser
circle is hard to see.
Right clicking on the photo will open a menu,
where you can choose what you want to do.
Additional software features
If you choose “Paint circle” the following window
appears.
With the distance slider you could adjust the
size of the laser circle drawing corresponding to
the original size of the real laser circle.
NOTE: This feature will only work properly, if
you have adjusted once the circle drawing
to the camera with the following procedure:
Ta ke a photo - enlarge it in the software - draw
a laser circle - adjust the size with the distance
slider as shown above - adjust the place of the
circle by using “Adj.” and then these sliders.
The drawing will be stored within the photo. The
same happens with the description function.
With the “Copy image” function you can create
a report easily by pasting the photo into a pro-
gramme of your choice.
“Print Image” starts the printers dialog of your
standard printer. Now you can print out a single
photo.
To Next Page
Loading...
