Troubleshooting
Code Problem Action
– – – (on display) Target temperature Select target within specifications
is over or under range
Battery icon Low battery Check and/or replace battery
Blank display Possible dead battery Check and/or replace battery
Laser doesn’t work (1) Low or dead battery (1) Replace battery
(2) Ambient temperature (2) Use in area with lower ambient
above 40°C (104°F) temperature
ERR Possible damage Contact your distributor
by EMF
Maintenance
Lens Cleaning: Blow off loose particles using clean compressed air. Gently brush
remaining debris away with a soft brush. Carefully wipe the surface with a moist
cotton swab. The swab may be moistened with water.
Note: Do not use solvents to clean the plastic lens.
Cleaning the housing: Use soap and water on a damp sponge or soft cloth.
Note: Do not submerge the unit in water.
CE Certification
This instrument conforms to the following standards:
• EN61326-1 EMC
• EN61010-1
• EN60825-1 Safety
Tests were conducted using a frequency range of 80–1000 MHz with the instrument
in three orientations.
Note: Between 165 MHz and 880 MHz (+/- 5%) at 3V/m, the instrument may not
meet its stated accuracy.
English
8
To Next Page
Loading...
Need help?
General
