4
ASSEMBLY AND SET-UP
PRE-RIDE CHECKLIST
1 Remove the four (4) coupling
bolts from the front fork using
a 5 mm Allen wrench and a
10 mm wrench.
1 Using two (2) 5 mm Allen
wrenches, remove the four (4)
coupling bolts from the frame.
2 Insert the wheel assembly into
the front fork and align holes. When
installing the wheel, make sure the
letter “F” and arrow (located on
the side of the wheel) are facing the
direction as shown above.
2 Align the four (4) holes in seat
with the four (4) holes in frame.
Insert the coupling bolts through the
top and bottom of the frame.
3 Reinsert the coupling bolts
through the front fork and
tighten securely.
3 Tighten the coupling bolts using
two (2) 5 mm Allen wrenches.
Attaching the Front Wheel
Required Tools: 5 mm Allen Wrench and 10 mm Wrench
Attaching the Seat
Required Tools: Two (2) 5 mm Allen Wrenches
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
Wheels
Periodically inspect the wheels for excess wear.
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken
frames are rare, it is possible for an aggressive rider to
run into a curb or object and wreck and bend or break the
frame. Get in the habit of inspecting your scooter on a
regular basis.
Hardware/Loose Parts
Check and secure all fasteners before every ride. Make sure
the steering bolt and casters are tight. There should not be
any unusual rattles or sounds from loose parts or broken
components. If the unit is damaged, do not ride. Reference
“Safety Warnings” on page 1 of this manual.
Safety Gear
Always wear proper protective gear, such as an approved
safety helmet. Elbow pads and kneepads are recommended.
Always wear closed toe shoes (lace-up with rubber soles) and
keep shoelaces tied and out of the way of the wheels. NEVER
RIDE BAREFOOTED OR IN SANDALS.
Laws and Regulations
Always check and obey any local laws or regulations.
Be Careful!
This product is not for aggressive or trick riding. Avoid steep
inclines and don’t ride too fast — you can lose control and
fall. Skateboard parks are not designed for young riders. Never
ride in traffic or on the street and watch your surroundings for
pedestrians, bikers, boarders and skaters.
Maintain a hold on the handlebars at all times.
To Next Page
Loading...
Need help?
General
