3
HEADLINEASSEMBLY AND SET-UP
3
Attaching the Deck Assembly
Required Tool: 5 mm Allen Wrench (included)
Attaching the Handlebars
Required Tool: 5 mm Allen Wrench (included)
1 Place the deck assembly onto
the frame. Then using a 5 mm Allen
wrench, tighten the left, right and
rear screw in that order.
1 Place the handlebar stem onto
the front fork.
2 With the front wheel pointed
straight ahead, the handlebars
square to the front wheel and the
Razor logo facing the front, use a
5 mm Allen wrench to tighten
the two (2) bolts on the collar
clamp. The collar clamp is properly
tightened when the handlebars
cannot be twisted out of alignment
with the front wheel.
Note: The cable assembly from the
handlebar must not wrap around
the handlebar stem. Sharp bends
or twisting of the brake cable can
cause the brake to malfunction.
To Next Page
Loading...
