Razor PowerRider 360

Need Help? Visit our web site for replacement parts and product support at www.razor.com or call toll-free at
866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time. Please have the product I.D. code (located on the white
label on your product or back of charger) available for better assistance.
10
REPAIR AND MAINTENANCE
q Adjusting the Brake
Required Tools: Phillips screwdriver, 10 mm wrench
1 To adjust the brake cable
tension, thread the brake lever
adjuster in or out 1/4 to 1/2 turn
until the desired brake adjustment
in attained. Most adjustments are
complete at this step. If the brake
still needs further adjustment,
proceed to the following steps.
4 If the brake is too tight or too
loose, use a 10 mm wrench to
loosen the nut on the brake cable
for additional adjustment. Securely
tighten the nut when finished.
2 Using a Phillips screwdriver,
loosen the two (2) screws on the
foot pegs.
5 Replace the motor cover/
chain guard. Refer to steps 2
and 3 above.
3 Using a Phillips screwdriver,
loosen the six (6) screws to remove
the motor cover/chain guard.