Need Help? Visit our web site for replacement parts and product support at www.razor.com or call toll-free at
866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time. Please have the product I.D. code (located on the white
label on your product or back of charger) available for better assistance.
3
BEFORE YOU BEGIN
Push Button Throttle
Front Wheel Assembly
Foot Peg
Hand Brake
Rear Caster Wheels
Seat
Remove contents from box and check parts against parts diagram found on page 13. Remove the separators that
protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint or
dents that may have occurred during shipping. Because the PowerRider™ 360˚ was partially assembled and packed at
the factory there should not be any problems, even if the box has a few scars or dents.
q Estimated Assembly and Set-Up Time
Allow up to 15–20 minutes for assembly.
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR POWERRIDER 360˚.
The PowerRider 360˚ has been
built to certain Razor design
specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may not
be compatible and will void your
warranty.
q Required Tools
5 mm Allen wrench
(Included)
8 mm/10 mm/14 mm/17 mm
wrenches
(Not included)
Valve Extender
(Located in the right
handlebar grip)
PRODUCT I.D. CODE
1. Underneath Frame
2. Charger
3. UPC Side of Box (not shown)
Charger
Bicycle tire pump for
Schrader valves, with
pressure gauge
(Not Included)
Phillips screwdriver
(Not Included)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
