Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
BEFORE YOU BEGIN
Remove contents from box and check parts against part diagram below. Remove the separators that protect the
components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked
cables that may have occurred during shipping. Because the PowerWing DLX is partially assembled and packed at the
factory, there should not be any problems even if the box has a few scars or dents.
Estimated Assembly and Set-Up Time
Allow up to 15–20 minutes for assembly. Razor recommends assembly by an adult.
Required Tools
Two (2) 5 mm
Allen Wrenches
(Included)
PRODUCT I.D. CODE
1. Side of frame
2. Barcode on side of box
(not shown)
Box Contents:
• PowerWing DLX
• Allen Wrench
• Owner’s Manual
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR POWERWING DLX.
The PowerWing DLX has been
built to certain Razor design
specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame,
fork and all other parts. Certain
aftermarket products may not be
compatible and will void
the warranty.
To Next Page
Loading...
Need help?
General