ASSEMBLY AND SET-UP
4
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
2 Squeeze the brake lever to
test the brake to make sure it is
working properly. The front fender
should clamp down and rub against
the front wheel. If brake is not
working properly, proceed to the
next step.
1 To adjust the brake cable wire,
thread the brake lever adjuster in or
out 1/4 to 1/2 turn until the desired
cable tension is attained.
Adjusting the Brake
3
If the brake is too tight or too
loose, use a 8 mm wrench and
a 3 mm Allen wrench to make
adjustments as needed.
WARNING:
Failure to properly tighten the
wedge may allow the handlebars to
dislodge while riding and may cause
you to lose control and fall. When
correctly tightened, the handlebars
will not rotate out of alignment
with the front wheel, under normal
circumstances.
4 Using a 5 mm Allen wrench,
tighten the stem bolt. The stem
bolt is properly tightened when the
handlebars cannot be twisted out of
alignment with the front wheel.
5 Bring the handlebar stem back
to the upright position.
6 Swing the black folding knob
to the 12 o’clock position and
tighten by hand until handlebars
are secure.
To Next Page
Loading...
Need help?
General