7
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
USAGE
7
Stopping the Electric Scooter
Release the throttle (A) and apply the brake, by squeezing brake lever (B).
Note: When coming to a complete stop, place both feet on the ground to
balance the unit.
B
A
REPAIR AND MAINTENANCE
Turn power switch “OFF” before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power off
• Secure the product under repair
• Exercise caution around
exposed parts
• Contact Razor customer service
if unsure about any repair or
maintenance
• Repair and maintenance should
be performed by an adult only
Testing the Brake
To use the brake, squeeze the brake lever to increase the pressure on the brake. The brake lever is fitted with a cable
adjuster to compensate for cable stretch and/or to fine-tune the lever movement to engage the brake. If brake is not
engaging properly, follow instructions for adjusting the brake outlined below.
Adjusting the Brake
Required Tool: 10 mm Wrench (included)
1 To adjust the tension, thread
the brake lever adjuster in or out
1/4 to 1/2 turn until the desired
brake adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2.
2 If the brake has too much slack,
use a 10 mm wrench to loosen the
brake anchor cable for additional
adjustment and retighten.
WARNING: The brake
is capable of causing the electric
scooter to skid the tire, throwing
an unsuspecting rider. Practice in
an open area free from obstacles
until you are familiar with the brake
function. Avoid skidding to a stop as
this can cause you to lose control or
damage the rear tire.
Note: The brake lever contains a
safety switch to cut power to the
motor when the brake is applied. In
an emergency, applying the brake
will always stop the product from
moving. Do not disable or replace
this lever with anything other than a
genuine Razor replacement part.
WARNING: The brake is
capable of skidding the rear tire
and throwing an unsuspecting rider.
Practice in an open area free from
obstacles until you are familiar with
the brake function. Avoid skidding to
a stop as this can cause you to lose
control and/or damage the rear tire.
Note: As an additional safety
feature, the scooter is designed to
cut power to the motor when the
brake is applied.
Note: Practice riding only in wide
open areas clear from curbs,
parking blocks and other obstacles.
Impacting the wheels against
any hard surface can damage the
wheels. Wheels are not covered
under the limited warranty.
To Next Page
Loading...
Need help?
General
