70
When changing the fittings make sure that they are not cross
threaded when screwing them in. The best way to do this is
to turn anti clockwise until the threads drop into position
and then tighten gently. No force should be used to get the
threads started.
1.2 Overview
1 The Razor BAT Wing
When the Inflator hose is unscrewed remember
to also take out the sealing O ring and replace
it in the other fitting so that the flat
side of the inflator elbow will seal against
the flat side of the O ring.
The inflator elbow is keyed and it is
important that it drops into position
so that it will seal on the O ring
when the fitting is screwed
back into place.
To Next Page
Loading...