76
The waist bungee should be fairly snug with the wing completely deflated and
both bungee cords will need to be adjusted to achieve the correct length and
tension to keep the BAT wing in a nice low profile position when it is inflated
and to prevent it from floating away from the divers body.
It will take a little bit of trial and error to get the length/tension correct so leave
the bungee cords long to begin with and do not tie the knots too tight so that
they can be released and moved easily if necessary.
Once the correct length is achieved then any excess bungee can be cut off and
the ends of the cords burnt to seal them and the knots snugged tight.
Step 2: Attaching and Adjusting the BAT Wing Waist Bungee
2 Rigging the Razor BAT Wing
To Next Page
Loading...
Need help?
General