81
Step 4: Adjusting and Attaching the Inflation Hose
2 Rigging the Razor Harness:
The oral inflator mouthpiece should now face up towards the diver along
with the power inflator button and Schrader valve.
The large diameter inflation hose will run over the kidney area under the arm
and across the lower chest. The end of the Power inflator will be attached to
the D ring on the opposite shoulder with a loop of bungee cord tied with a
Fisherman’s knot through the loop of a small swiveling snap bolt.
The bungee loop can be positioned between the large diameter inflation
hose and LPI hose while diving so that it is securely retained.
The LPI hose to the power inflator should route directly across the chest
from the 5th port in the end of the swiveling turret of the regulator first
stage.
It will run under the large diameter inflation hose.
To Next Page
Loading...