Setting the Security Code
This
feature allows you to change the factory default remote
access
code
used
for
remote access
to you
answerer
.
The
default
code is
123.
1. Press
and
release
the
MENU
button until the
screen displays
REMO
TE
ACCESS”
2. The left-most
digit
,
or a
(_)
sign flashes indicating the unit is ready to
accept
the
security code
entry.
3. Use the keypad number to set the 3-digit security code in one
step
.
4.
After
the 3rd and last digit is entered, press the
MENU
button to
store
the
security code
and go to the next setting.
NOTE:
To
skip to the next setting, press
MENU. To
exit setup,
pr
ess
E
XIT
.
N
O
TE
:
If
you make a mistake, you can use
SKIP
or
REPEAT
to m
o
v
e
between 1st to 3rd digit and input number from keypad
again.
Setting the Display Contrast
This setting allows
you to
adjust
the
display contrast
for
easier
readability.
1. Press
and
release
the
MENU
button until the
screen displays
CONTRAST
.
2. Use
SKIP
or
REPEAT
to select the desired setting (1-5).
3. When finished, Press
MENU
to confirm setting and go to next
setting.
NOTE:
To
skip to the next setting, press
MENU. To
exit setup,
pr
ess
E
XIT
.
Setting
Y
our Local Area Code
1. Press
and
release
the
MENU
button until the
screen displays
LOCAL
ARE
A
C
ODE
.
2. The left-most
digit
,
or a
(_)
sign flashes indicating the unit is ready to
accept
the
area code
entry.
3. Press the keypad number to set the 3-digit local area code in one
step
.
4.
After
the 3rd and last digits are entered, press the
MENU
button to
store
the
area code
and go to the next setting.
N
O
TE
:
If
you make a mistake, you can use
SKIP
or
REPEAT
to m
o
v
e
between 1st to 3rd digit and input the number from the
k
e
y
p
a
d
again.
NOTE:
To
skip to the next setting, press
MENU. To
exit setup,
pr
ess
E
XIT
.
To Next Page
Loading...
Need help?
General
