»»
All
old
messages
are
permanently
deleted.
Note
••
You
can
delete
the
read messages only. No deleted messages
can be
recovered.
Call
scr
eening
You
can hear the caller while he is
leaving
a
message.
Press to pick up
the call.
From
the
base
Press +
/
- to
a
d
j
u
st
the speaker volume
du
r
i
ng
c
a
ll
s
c
r
ee
n
i
ng
.
T
h
e
l
o
w
est
volume level
turns off the call
scr
eening.
Set
the
ring
delay
You
can set the number of times the phone rings before the answering
machine picks
up the call.
1 Press
MENU
.
2 Select
[ANSWER MACHINE] >[SETTINGS]
>
[RING DELAY],
then press
[OK]
to
confirm.
3 Select a new setting, then press
[OK]
to confirm.
»»
The setting is saved.
Note
•
Ensure
that the
answering
machine is switched on before this feature can
be applied.
Tip
When
you
access
the
answering machine remotely,
you are
recommended
to
set the ring delay to
[ECONOMY]
mode.
This
is a cost effective way to
manage
your messages.
When
there are new
messages,
the
answering machine picks
up the call after
3
rings; when
there
are
no
messages;
it
picks
up the call after 5
rings.
Remote access
T
h
e
un
i
t
answers
after 10 r
i
ng
s
if
i
t
i
s
turned off
. To
access
the
a
n
s
w
e
r
i
ng
system, enter your 4-digit
PIN
CODE.
You
can operate your
answering
machine when you are away from
h
o
m
e
.
S
i
m
p
l
y
make a call to your phone with a touch tone phone and enter
y
o
u
r
4-digit
PIN
code.
Note
•
The remote access PIN code is
the
same as
your
system PIN. The preset
PIN
is 0000.
Activate/deactivate
the
remote access
You
can allow or
block remote access
to the
answering
machine.