RCA 2132

37
“When I try to make a
call, I hear busy tone”
If you‟re using a multi-handset system, check
whether another handset is already on a call.
“The volume in the
earpiece is low when I‟
m on a call”
Make sure you‟re holding the earpiece correctly
over your ear .
Adjust the volume using the navigation key.
Intercom and transfer
“I can‟t transfer a call”
Make sure the other handset is in range of the
base unit .
Make sure you are dialing the correct number for
the other handset .
Battery
“The handset‟s battery
pack is running low
within an hour or tw o”
Before you first use the handset , you should
have left it on the base unit or charger pod for 16
hours to charge the battery fully.
You may need to replace the battery.
Check the connection between the base unit and
the main power sock et .
“I try to recharge the
battery but I still get a
warning that they are
low”
You need to replace the battery.
Dispose of used batteries safely – never burn
them, or put them where they could get
punctured.
Do not use non-rechargeable battery in your
handset – they may explode, causing damage.
If the fault persists... Disconnect all other
instruments connected to the same line and tr y
to make a call.
Disconnect the base unit from the telephone line
and plug a different phone into the master
telephone sock et . Try making a call. If this works,
the line is OK .
If the call does not w ork , and you are using a
two-way socket adaptor , remove it and plug a
telephone directly into the sock et .
If the call now works, the adaptor may be faulty.
If you cannot make a call, the fault may be on
the exchange line. Contact the service pr ovider .