Set Work Hours
This will allow you to program the start time your day or the opening time of your business
From the Set Oce Time Menu:
1. Press the VOL (- or +) button to scroll to Set Work Hours .
2. Press the OK Soft key to conrm.
3. Use the dial pad to enter the start, or opening time of your business.
4. Press the OK Soft key to save.
5. Select the Yes or No soft key for Announce Only. Your time will be saved automatically.
NOTE: If you select Yes for Announce Only, corresponding OGM MUST be recorded rst.
NOTE: When the unit is in the Answer Only mode, your callers will hear your OGA only and will not have the op-
portunity to leave a voice message for you.
Set After Hours
This will allow you to set the end, or closing time of your business.
From the Set Oce Time Menu:
1. Press the VOL (- or +) button to scroll to Set After Hours .
2. Press the OK Soft key to conrm.
3. Use the touch-tone pad to set the time.
4. Press the OK Soft key to save.
5. Select the Yes or No soft key for Announce Only. Your time will be saved automatically.
NOTE: If you select Yes for Announce Only, the corresponding OGM MUST be recorded rst. The unit will hang up
the call after announcing the greeting when answering the call is in the answering mode.
NOTE: When the unit is in the Answer Only mode, your callers will hear your OGA only and will not have the op-
portunity to leave a voice message for you.
Call Screening
From the Settings Menu:
1. Press the VOL (- or +) button to scroll to Call Screening .
2. Press the OK Soft key. Use the VOL (- or +) button to select On or O .
3. Press the OK Soft key to save your selection.
Note: the Default setting is On.
Remote Access
From the Settings Menu:
1. Press the VOL (- or +) button to scroll to Remote Access .
2. Press OK Soft key. Use the VOL (- or +) button to select On or O or Change PIN.
On or O
3. Press the the OK Soft key to save your selection.
Note: The default setting is On.
13
To Next Page
Loading...
Need help?
General
