NOTE: A name must be assigned, otherwise the record cannot be stored.
5. Press the OK Soft key. The desired redial number shows in the display.
6. You can edit the telephone number by using the Delete button key and number keys.
7. Press OK Soft key to save your entry.
Ringer On/O and Ringer Volume
1. Make sure your phone is in idle mode. (not in Talk mode)
2. Press the VOL (- or +) button to activate the ringer volume setting.
3. Press either the LINE 1 or LINE 2 Soft key to select the desired line.
4. The LCD will display the volume range and currently-selected volume in an ascending series of bars.
5. Press the VOL (- or +) button up or down to increase or decrease the volume in steps.
6.The system will retain the last entry, it is not necessary to save or acknowledge your selection from this mode.
Speakerphone, Handset and Headset Volume
While the phone is in use, during the desired mode, press the VOL (- or +) button until you reach your preferred
listening level. The phone will retain the last entry, it is not necessary to save or acknowledge your selection
from this mode.
Hold
In Talk mode, press the hold button to place the line on hold. The line icon will ash red.
When the line is on hold, the hold alert tone will be emitted to both the held party and to the user that initiated
the hold.
Press the corresponding LINE button to release the hold and resume the held call.
Conference Calls
This system can support 3-way conference calls.
1. During a call on Line 1, press the hold button to place the call on hold.
2. Press the Line 2 button to get a dial tone. Dial the other number and wait for the call to connect.
3. Once the 2nd call has connected, the user can press the CONF Soft key to establish a 3-way conference call
between the two lines.
22
NOTE: More than one letter is stored in each of the number keys so it requires more than one press
for some letters. For example, for the letter “B” press the number 2 key twice. To add a space, press
the 1 key.
To Next Page
Loading...
Need help?
General
