13
Basic Operation
Load Default
1. Press Menu button once, then press the VOL ( + or -) buttons until LOAD DEFAULTS is
displayed.
2. Press Select/Save button to select.
3. Scroll the VOL ( + or -) buttons to select YES.
4. Press Select/Save button to reset to the default settings.
Set Time
The time cannot be set manually in the handset, only at the base. Any update to the base
time will be automatically sent to the handset.
Registration (Re-Registration)
Registration links the cordless handset to the base which allows the handset to use the
base’s phone connection. A cordless handset will not operate until it is registered to the
base. Your handset comes pre-registered and ready-to-use. If your handset and/or module
becomes damaged or lost, you will need to purchase a new handset/module unit.
If your handset becomes unregistered, it may be necessary for you to re-register to the
base. To do so follow the steps below, keep the handset near the base at all times.
1. Press Menu button once, then press the VOL ( + or -) buttons until PHONE SETTING is
displayed.
2. Press Select/Save button to select.
3. Scroll the VOL ( + or -) buttons until REGISTRATION is displayed.
4. Press Select/Save button to select. The display shows SEARCHING.
5. On the base, press and hold the Page button for 10 seconds. If the registration succeeds,
the display of the handset will show SUCCESSFUL and has a short beep sound.
6. If the registration fails, FAIL! TRY AGAIN will show on the handset display. Please repeat
the above steps.
Basic Operation
Answering a Call
1. Press the Talk or Speaker button on the handset. (The base displays CORDLESS H/S IN
USE).
2. When finished, press the Talk or Speaker button or replace the handset in the charge
cradle to hang up.
To Next Page
Loading...
Need help?
General
