Using the Battery to Power Your Camcorder
The battery must be charged as described on the next
page
before it can be used the
first time. Initial charging will take approximately 70
minutes. When fully charged,
the battery should supply about 55 minutes of operating time (depending on how much
you use zoom and pause). Conserve battery power by turning the camcorder off during
recording breaks.
Note: The small marker switch on top of the battery is for use as a personal reminder to help
you remember to recharge the battery.
It has no other function.
BATTERYRELEA
(VCRfOFFlCAMER.4)
Switch and Indicator
Attach the Charged Battery
If the power connector is attached to the
3. Place the
POWER
switch in
CAMERA.
camcorder, remove it before attaching the
The
POWER
indicator will light.
battery. Also, install the lithium clock
cell before attaching the battery pack.
Remove the Battery
Details on page 28.
Press and hold
BATTERYRELEASE
on
1. Align the reference mark on the battery
the camcorder while sliding the battery to
with mark on back of camcorder.
the left and off.
2. Hold battery flush against camcorder
and slide it in direction of arrow.
ATTENTION: THE PRODUCT THAT YOU HAVE PURCHASED
USES A RECHARGEABLE BATTERY. AT THE END OF ITS
USEFUL LIFE, UNDER VARIOUS STATE AND LOCAL LAWS, IT
@
MAY BE ILLEGAL TO DISPOSE OF THIS BATTERY INTO THE
I
w
MUNICIPAL
WASTE STREAM. CHECK WITH YOUR LOCAL
Ni-Cd
SOLID WASTE OFFICIALS FOR DETAILS IN YOUR AREA FOR
RECYCLING OPTIONS OR PROPER DISPOSAL.
17
To Next Page
Loading...
Need help?
General
