Using the Battery to Power Your Camcorder
(continued)
To AC Wall Outlet 100440
Adapter/Charger
-
Side-B
Ch’ARGE
Indicator
END Indicator’
Battery Release Switch
POWER
Indicator
CH-iRGE
Indicator
aptedcharger
-
Side A
END
Indicator’
Battery Release Switch
A
hIFRESH
Switch
and Indicator
Charging Batteries
If the power connector is attached to the
DC
OUT jack on the adapter/charger,
remove its plug.
1. Plug adapter/charger into nearest AC
outlet
(Ml-24OV,
50/6OHz).
The
POWER indicator lights.
2.
3.
I
I
I
Align reference mark on battery with
mark on adapter/charger and press
battery pack-in until it locks.
If the battery is properly connected, the
CHARGE
indicator on that side of the
adapter/charger will flash.
Notes: You
may charge two batteries at
the same time. Whichever battery
you
attach first will charge first. The CHARGE
3. When discharging is completed, the
indicator will light for the battery that
is
REFRESH
indicator will turn off, and
waiting to be charged.
the
CHARGE
indicator will flash while
If you try to charge a battery that has not
the battery charges.
been charged for a long period of
time, it
may take a few minutes for the
CHARGE
indicator to flash.
Use
REFRESH
on Side
A
The battery will provide increased
operation time if you “refresh)) it after
five charges. The
REFRESH
feature
“refreshes’? the battery by completely
discharging it.
1. Attach battery to side
A
of the
adapter/charger.
2. Press REFRESH. The REFRESH
indicator will light and the battery will
begin discharging.
Note:
The battery you .attach to side
A
will
always be refreshed first. Then the battery
attached to side B will be charged before
the battery in side
A.
4. After the battery is charged, the
END
indicator will light.
_
_
.._
4. After one battery is charged, its
END
5. Press the battery release
switch
whrle
indicator will light. The other battery’s
removing the battery from the
CHARGE
indicator will flash while it
adapter/charger.
is being charged.
(continued on next page)
18
To Next Page
Loading...
Need help?
General
