E
I’
!
I
I1
I
1
I’
!
I
The time-counter display shows the actual time elapsed when recording a program or
playing back a segment of a prerecorded tape.
It helps you locate the end of programs.
Note the time counter reading when you finish recording or playing back a tape. For
example, you recorded for 10 minutes. Later,
you
want to locate the end of your
recording
-
insert the tape, display the time counter, and fast forward the tape until the
time counter reads “0:
1O:OO”.
RESET Button
COUNTER MEMORY Butt
REW Button
POWER Switch
To Use the Memory-Stop Feature
The memory-stop feature helps locate a
certain point on the tape. When memory
stop is on, the tape will stop
automatically during rewind or fast
forward when the time counter reaches
M
O:OO:OO.
1. Press COUNTER MEMORY to turn
the time counter’s memory-stop
feature on or off. When memory stop
is on, an
M
appears before the time
counter in the viewfinder.
Time Counter
M
0:OO:OO
Display.with
Memory Stop
Turned
On
Viewfinder Display
2. Locate the place on the tape you want
to return to, and press
RESET
to set
the time counter to
M
0:OO:OO.
3. Continue to record or play the tape.
When you want to return to the place
you marked, press the thumb trigger to
stop recording, or the
STOP
button to
stop playing back the tape.
4. Place the POWER switch in VCR.
Press REW. The tape will rewind to
the time counter reading of
M
0:OO:OO.
Notes: Whenever the time counter is
displayed, you can reset it to iU
0:OO:OO
by
pressing
RESET.
Whenever memory stop is on, the camcorder
will stop rewinding or fast forwarding when
the counter reaches h4
0:OO:OO.
To continue
rewinding or fast forwarding, press the
REW
or
FF
button again.
The time counter does not operate during
high-speed rewind or fast-forward operation.
The time counter’s memory is automatically
cancelled when the power supply is
disconnected.
38
To Next Page
Loading...
Need help?
General
