Setup and Connections
4
Step 1: Unpack the DIRECTV System
Make sure to locate the remote control.
Step 2: Connect Your Digital
Satellite Receiver
During the satellite dish antenna installation, the digital satellite
receiver may have been connected to your TV with just a coaxial cable
for the system test. Depending on what components you have, another
connection may provide better picture and audio quality. The following
sections provide cable and connection information to help you decide
what connection is best for you.
Things To Know Before Connecting
Components
Protect Your Components from Power Surges
• Connect all components before plugging any power cords into the
wall outlet.
• Always turn off the digital satellite receiver, TV and other
components before you connect or disconnect any cables.
Position Cables Correctly to Avoid Audio Hum or
Interference
• Insert all cable plugs firmly into their jacks.
• Place the audio/video cables to the sides of the TV’s back panel
instead of straight down the middle after you connect your
components.
• Try not to coil any twin-lead cables and keep them away from the
audio/video cables as much as possible.
• Make sure all antennas and cables are properly grounded. Refer to
the Safety Tips sheet packed with your unit.
Protect Your Components from Overheating
• Do not block ventilation holes in any of the components. Arrange
the components so that air can circulate freely.
• Do not stack components.
• Allow adequate ventilation when placing your components in a
stand.
• Place an amplifier or receiver on the top shelf of the stand so
heated air rising from it will not flow around other components.
Digital Satellite Receiver
Remote Control
To Next Page
Loading...
