RCA DRD420RE - Video Input Channel Variations

Tips & Troubleshooting
64
Finding the Video Input Channel
On Your TV
Note: If your TV is connected with just coaxial cables, you only need to
tune to channel 3 or 4.
If you used audio/video cables to connect your TV to the digital satellite
receiver, you must tune your TV to the video input channel to view
DIRECTV
®
programming and menus. There are just as many ways to
access a TV’s video input channel as there are brands and models of TVs.
Below are some things you can try.
• If your TV brand is RCA, GE, or Proscan, press TV on the remote
control that came with your DIRECTV System. Then press the
WHO•INPUT button on the remote.
• If your TV brand is not RCA, GE, or Proscan, consult your TV Owner’s
Manual.
If you cannot find your TV Owner’s Manual, you will have to investigate.
You might access the TV’s video input channel by:
• pressing a button on the remote control
• finding it through the TV’s menu system
• tuning directly to it by pressing a specific channel number
• going through all channels in the list by pressing the channel up or
down buttons on the TV
The box below lists some of the different ways manufacturers label the
video input channel.
Video Input Channel Variations
Button/switch
on the TV
VIDEO
SIGNAL
VID 1
VID 2
S-VID
S-VIDEO
Button on the
TV Remote
VID 1
LINE
VID
VIDEO
S-VID
INPUT
SOURCE
AUX
Channel #
00
90
91
92
VID 1
VID 2