Copyright © 2019 RCA Communications Systems
Prodigi
TM
RDR1520 Series Professional Digital Two-Way Radio Instruction Manual
16
6. If there is no talking on this channel during
a preset time, the call ends.
7. A short tone will be heard.
Receive all call
All calling is one radio call to other radios in
the same channel. When you receive all calls:
1. An alert tone is heard and the LED indicates
green.
2. If there is no talking on this channel during
a preset time, the call will end. If “CH free
indication” was enabled, you will hear the
short beep tone when your partner releases
the PTT, it means the channel can be used,
but you cannot respond to all calling.
Attention!!
♦ When receiving all calling, you switch
to another channel, the radio will stop
receiving the all calling.
♦ During the calling, you cannot use any
preset button until the calling was end.
Send the transmission
You can use 2 ways to select a channel, user’s
ID or group ID. :
1) Rotate the channel knob
2) Press Preset One Touch Access key
Rotate the channel knob to send a
Group Call transmission
To send the group call, your radio must belong
to this group:
1. Rotate the channel knob, use the group ID
to select the channel.
2. Hold the radio 1-2 inches (2.5-5cm) distance
from your mouth.
3. Press PTT to transmit the call; the LED
indicates red.
4. You hear the “Call permit” tone (if enabled)
and speak into the mic.
5. Release PTT to receive, LED indicates green
if your partner is answering.
To Next Page
Loading...
Need help?
General
