Battery Installation
and Information
Your universal remote requires two AAA Alkaline
batteries (batteries may or may not be included,
depending on model). To install the batteries:
Your universal remote control saves battery power
by automatically turning off if any key is pressed for
more than 60 seconds. This saves your batteries should
your remote get stuck in a place where the keys remain
depressed, such as between sofa cushions.
1. Remove the battery
compartment cover.
2. Insert the batteries, matching the
batteries to the (+) and (-) marks
inside the battery compartment.
3. Press and push the battery cover
back into place.
Battery Saver
3
Congratulations on your purchase of this four-component
universal remote. Your universal remote controls up to
four electronic components and makes juggling remote
controls a thing of the past. You can program your
RCA brand universal remote to operate most models of
most brands of infrared, remote-controlled components
manufactured after 1990. (See the enclosed Code Lists for
a complete list of brands.) And, not only is your remote
easy to program, it’s easy to operate, too.
We’ve specially
designed this remote with big buttons to give you total
control…at the touch of your fingertips.
The four-component universal remote is already
programmed to operate most RCA, GE and PROSCAN
branded TVs, DVD players and satellite receivers. Just
press the corresponding key—VCR for a VCR player;
DVD for a DVD player; TV for a television; SAT·CBL for a
satellite receiver or a cable box.
Four-Component Universal Remote
!
TIP:
Note: Reprogramming may be required after batteries
are replaced.
Battery Precautions:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargable (nickel-cadmium) batteries.
• Always remove old, weak or worn-out batteries
promptly and recycle or dispose of them in
accordance with Local and National Regulations.
To Next Page
Loading...
Need help?
General
